How to Install a Kitchen Cabinet Light Rail

Kitchen is the busiest room in the house, it’s where we cook, eat, and gather around to discuss our lives. There are many things that can be done with your kitchen to give it a sleek look, without the need of any major renovations. Depending on the budget, you can add plenty of new stuff to decorate your kitchen.

Installing wooden cabinets light railing is an economical way to improve the look of your kitchen.

Instructions

  • 1

    Light Rail should be Flush:

    Purchase good quality light rail from a wood store and place it in a clean dry place. Make sure that the panels are smooth and check their level with a builder’s level. The installed cabinet and the light railing should be flush; if they are not flush, use a wooden file to make the light railing smoother.

    Mark the light railing at the edges of the cabinet and cut them up in a diagonal way to give them a good look. You can also use filler between the cabinet and railing in case the need arises.

  • 2

    Cut a piece of railing:

    Use a wooden saw to cut the first piece of the light rail at an angle of 45 degrees. The centre point of the railing should be where the markings on the railing intersect.

  • 3

    Cut another piece of the rail:

    If your cabinet is square, it means that the other side of the light rail needs to be of the same length. However, if both sides are not of equal length, place the wood chunk on side of the cabinet wall and mark its corner points. Use the wooden saw to cut the plank at an angle of 45 degrees and put it aside along with the finished products.

  • 4

    Fix first piece:

    First place the horizontal piece below the cabinet and check whether the cutting point of the 45 degree angle meets the edge of the cabinet. Nail the plank to the cabinet with the help of hammer and wooden nails.

  • 5

    Make a small front piece:

    Cut a small piece for the front end of the cabinet, it should be at least 5 inches longer than the face of the cabinet. Attach front piece to the side piece of light rail and attach it with the cabinet with the help of nails or binding glue.

Leave a Reply

Your email address will not be published. Required fields are marked *


nine − 4 =