How to Set a Bike Computer
If your bicycle riding habit is becoming dull, a cycle computer or a bike computer is a good way to gear up your ride. This is a lot of fun and you can compete with yourself by tracking distance covered, average speed, top speed and current speed, even on beginner level models. If you go more hi tech you can get variables like heart rate and cadence as well. However, this works like any other computer and you need to set a bike computer. Adjusting the tire size guarantees accurate readings. Moreover, make use of the roll out method for better measurements.
Instructions
-
1
Read your bike computer’s guide book
Go through the bike computer’s instruction book. This works just like the cell phone, digital camera or other computer device, and functions and settings of the bike computer differ with every model. You should consult on how to change settings and manipulate through functions. A “mode” button is normally in between the process and so are arrow keys and “set” or “reset” buttons. This will help you in getting to know the abilities of the cycle computer and increase your expertise. -
2
How to add the component?
Put the cycle on a hard and level surface. Place the front wheel’s valve stem at a lower position as recommended by Trek Bicycles. Make sure the valve stem is perpendicular to the surface. Identify the spot under the valve stem with a tape or chalk. Move the cycle ahead one complete circle until the valve stem is at the same position as before. Mark the surface again with a chalk under the valve stem. Trek suggests placing weight on the handlebars. A partner is ideal at this time and he can help you mark the spot. -
3
Arrange your desired settings on the cycle computer
Put basic functions in place like time and the way you want to see data that is usually in km or mph. Go to the settings that tell you to enter a code according to the cycle’s tire size. Most of the cycles make it a very simple process. Check your tire’s size on its sidewall, read the manual for the given code and input it into the computer. If want the reading to be more precise, you can use the roll out way to know the tire size setting.
